Before Use; Temperature Control - Morphy Richards SEMI-ELECTRONIC 40715 Manual De Instrucciones

40715-40-41 inc AUS:9225 47507 MEE pump - Jon

Before use

Sort out the items to be ironed
according to the type of fabric. This
will minimise the frequency of
temperature adjustment for different
garments.
Note: The steam facility should only
be used on garments which are
suitable for ironing at the 2 and 3
dot settings.
Textiles and clothes are supposed
to carry ironing instructions. If they
don't you should follow the fabric
guide on page 3, but be sure to test
the temperature by ironing the hem
of the garment or similar area first.
If you turn the control dial down
from a hot setting to a cooler
setting, wait until the iron
temperature has stabilised before
you continue ironing.
Delicate fabrics such as silk,
wool,velour, etc, are best ironed
with an ironing cloth to prevent
shine marks.
Filling
A
1 Make sure that the iron is not
plugged in, then set the steam to
dry iron selector switch ⁄ to
'0' position before filling the iron
with water.
2 Lift up the fill cap and fill the water
through the filling hole › into the
water tank ·, using the beaker
provided. A
1 beaker fills the tank (400ml). On
illuminated tank models, use 350ml
of water. After filling replace the fill
cap. In hard water areas the use of
distilled or demineralised water is
recommended.
WARNING: Never use battery
topping up fluid or water
containing any substances like
starch, or sugar, or defrosted
water from a refridgerator.
3 Always pour out the remaining
water after use.
WARNING: When filling your iron
with tap water always use the
beaker provided. Never fill
directly under the tap.
7/3/08

Temperature control

• Default setting + 3 dot (cotton)
• To increase temperature press the
top button.
• To decrease temperature press the
bottom button.
• The light panel will flash to indicate
that the iron has not yet reached the
correct temperature.
• Once the correct temperature has
been reached , the light will stop
flashing and there will be one 'beep'
to signal that the iron is now ready
for use.
B B
Increase
temperature
Decrease
temperature
15:28 Page 5
B
g
A
5