Morphy Richards SEMI-ELECTRONIC 40715 Manual De Instrucciones página 8

40715-40-41 inc AUS:9225 47507 MEE pump - Jon
8
To clean a coated
soleplate
In the unlikely event of any man-
made fibre fusing to the soleplate,
set the iron at the 3 dot position and
pass it over a clean piece of cotton
which will draw the deposit off the
surface.
Do not use scouring powder or
solution as this could cause
damage to the coating.
To clean the exterior
Allow the iron to cool and wipe over
with a damp cloth and mild
detergent, then wipe with a dry
cloth.
Emptying and storing
When you have finished ironing,
unplug your iron. Ensure that the
variable steam control is set at the
'0' position, lift up the fill cap and
empty any remaining water out of
the filling hole. Do not store in the
box, but in an upright position, so
that any drops of water remaining
cannot leak out and discolour the
soleplate H.
Important: The flex can be damaged
if wound too tightly around the iron
after use. Make a loose loop with
the flex and wrap it around the iron.
The iron must be cool before
winding the flex and storing on its
heel I.
7/3/08 15:28 Page 8
YOUR TWO YEAR
GUARANTEE
It is important to retain the retailers
receipt as proof of purchase. Staple
your receipt to this back cover for
future reference.
Please quote the following
information if the product develops
a fault. These numbers can be
found on the base of the product.
Model no.
Serial no.
All Morphy Richards products are
individually tested before leaving the
factory. In the unlikely event of any
appliance proving to be faulty within
28 days of purchase it should be
returned to the place of purchase
for it to be replaced.
If the fault develops after 28 days
and within 24 months of original
purchase, you should contact the
Helpline number quoting Model
number and Serial number on the
product, or write to Morphy
Richards at the address shown. You
may be asked to return a copy of
proof of purchase.
Subject to the exclusions set out
below (see Exclusions) the faulty
appliance will then be repaired or
replaced and dispatched usually
within 7 working days of receipt.
If for any reason this item is
replaced during the 2 year
guarantee period, the guarantee on
the new item will be calculated from
original purchase date. Therefore it
is vital to retain your original till
receipt or invoice to indicate the
date of initial purchase.
To qualify for the 2 year guarantee
the appliance must have been used
according to the manufacturers
instructions. For example kettles
should have been regularly
descaled.