Cleaning And Maintenance - Black and Decker Dustbuster V4800 Manual De Instrucciones

USE
Charging the battery (fig. C)
Make sure that the appliance
N
is switched off. The battery
will not be charged with the
on/off switch in the on
position.
Place the appliance on the
N
charging base as shown.
Plug in the charger. Switch on
N
at the mains.
Leave the appliance to
N
charge for at least 16 hours.
Whilst charging, the charger may
become warm. This is normal and
does not indicate a problem. The
appliance can be left connected
to the charger indefinitely. When
the battery is fully charged,
the power consumption of the
charger is negligible.
Important! Place the appliance on
the charging base whenever it is
not in use. After fully charging the
battery, the average effective usage
time is approx. 8 to 15 minutes
(depeding on the model). It may
take several charging cycles before
the battery attains full capacity.
Do not charge the battery at
ambient temperatures
below 4 °C or above 40 °C.
Operating the appliance (fig. D)
To switch on, slide the on/off
N
switch (1) forward.
To switch off, slide the on/off
N
switch back.
Accessories (fig. E & F)
V4810/V4820/V7210/V9650
These models are supplied with
the following accessories (fig. E):
- a hard brush (8) for furniture
and stairs (not for V4820)
- a crevice tool (9) for confined
spaces
E N G L I S H
- a soft brush (10) for keyboards
and lamp shades (V4820)
V9650
Two additional accessories are
stored in a portable caddy located
in the charging base:
- a soft brush (10) for keyboards
and lamp shades
- an extendable crevice tool (11)
for longer reach in confined
spaces
To fit an accessory, proceed as
follows (fig. F):
Take the accessories from the
N
appliance.
Insert the appropriate
N
accessory into the front of the
appliance.
TROUBLESHOOTING
If the product does not work,
follow the instructions below.
If this does not solve the problem,
please contact your local
Black & Decker repair agent.
Make sure the battery is fully
N
charged.
If the battery cannot be
N
charged, check if the charger
is plugged in correctly and
the mains is working.
Make sure the on/off switch is
in the off position.
CLEANING AND
MAINTENANCE
Regularly clean the filters.
Cleaning the dust bowl and
filters (fig. G, H, I & J)
The filters are re-usable and
should be cleaned regularly.
Press the release button (2)
N
and remove the dust bowl (3)
(fig. G).
Remove any dust from the
N
dust bowl (fig. H).
Remove the filters (12 & 13) by
N
twisting them clockwise (fig. I).
7