Publicidad
Idiomas disponibles
Idiomas disponibles
RECOMMENDATIONS
To obtain the best performance and for a long life of your cleaner we suggest you carefully
read the recommendations below:
USING STEAM
Before starting the machine fill the water tank so that the boiler generates steam. If the tank is
empty a led will go on indicating that there is no water.
Make sure that the plug of the steam hose or pipe is completely inserted in its seat (until you hear
a click).
Before using steam with the various accessories remember to discharge the steam condensation
accumulated with the first pass over with steam, distributing it on a cloth. Carry out this operation
every time you start to use the generator or after it has not been used for some time.
Select the steam dispensing speed by holding down the steam button based on the cleaning you
are doing and the accessories being used.
CLEANING: The output temperature of the various accessories can be in different scales. The
MAX temperature inside the lance is around 140°C while with free dispensing outside the
accessories the steam temperature may vary based on the distance from the surface to clean.
VACUUM:
Before use, it is very important to always put the necessary quantity of water (not distilled) in the
recovery basket (reaching the minimum level) to let the water filtering system trap the suctioned
dust.
Make sure the basket seal is not damaged, for better vacuuming.
Make sure the tank is housed perfectly in its seat, push it down using a slight force.
Make sure that the plug of the hose is completely inserted in its seat (until you hear a click).
Pay attention to the water level in the recovery basket, when the water reaches the maximum
level, the vacuum motor noise changes in intensity and the machine does not vacuum, empty the
tank and then make sure to add the minimum level of required water.
Use this device in a horizontal position only, to prevent vacuumed water from entering the vacuum
tube circuit and damaging the motor.
Warning: vacuuming any liquids other than water could damage the device
Before storing the machine, vacuum clean water to clean the tubes and carefully wash the tank
and relative internal components with running water and dry them, to prevent residual dirt from
sticking and unpleasant odours.
Store the machine in a dry place not subject to abrupt changes in temperature and in a horizontal
position.
LIBRA AND ITS ACCESSORIES
1. Machine Mod. Libra
2. Hose
4. Vertical nozzle
6. Horizontal nozzle
8. Extension pipes
10. Window cleaner 250mm
11. Brush 300mm
11A. Rubber frame 300mm
11B. Bristle frame 300mm
11C. Carpet frame 300mm
Publicidad
