Black and Decker BDT555KIT Manual De Instrucciones página 6

ENGLISH
Never attempt to remove or replace
u
any parts other than those specified in
this manual.
Additional safety instructions for
grass trimmers
Warning! Cutting elements continue to
rotate after the motor is switched off.
Be familiar with the controls and the
u
proper use of the appliance.
Before use, check the power supply
u
cord and extension cord for signs of
damage, ageing and wear. If a cord
becomes damaged during use, discon-
nect the cord from the mains supply
immediately. DO NOT TOUCH THE
CORD BEFORE DISCONNECTING
THE SUPPLY.
Do not use the appliance if the cords
u
are damaged or worn.
Wear stout shoes or boots to protect
u
your feet.
Wear long trousers to protect your
u
legs.
Before using the appliance, check that
u
your cutting path is free from sticks,
stones, wire and any other obstacles.
Only use the appliance in the upright
u
position, with the cutting line near the
ground. Never switch the appliance on
in any other position.
Move slowly when using the appliance.
u
Be aware that freshly cut grass is
damp and slippery.
Do not work on steep slopes. Work
u
across the face of slopes, not up and
down.
6
(Original instructions)
Never cross gravel paths or roads
u
while the appliance is running.
Never touch the cutting line while the
u
appliance is running.
Do not put the appliance down until the
u
cutting line has come to a complete
standstill.
Use only the appropriate type of cut-
u
ting line. Never use metal cutting line
or fishing line.
Be careful not to touch the line trim-
u
ming blade.
Take care to keep the mains cable
u
away from the cutting line. Always be
aware of the position of the cable.
Keep hands and feet away from the
u
cutting line at all times, especially
when switching on the motor.
Before using the appliance and after
u
any impact, check for signs of wear or
damage and repair as necessary.
Never operate the appliance with
u
damaged guards or without guards in
place.
Take care against injury from any de-
u
vice fitted for trimming the filament line
length. After extending new cutter line
always return the machine to its nor-
mal operating position before switching
on.
Always ensure that the ventilation slots
u
are kept clear of debris.
Do not use the lawn trimmer (edge
u
trimmer), if the cords are damaged or
worn.
Keep extension cords away from cut-
u
ting elements.