teutonia Trio Manual De Instrucciones página 43

Seat Unit Assembly
7.5 Pull the seat fabrics over the 2 buttons, repeat on both sides.
WARNING Always check that the seat fabrics fabrics is properly attached on both sides.
7.6 Take the fabric locking plastic part and locate the 2 buttons, that carry the fabrics on both sides.
7.7a) Put the fabric locking plastic part and place it over the 2 buttons. Press towards the foot end. Then push the
plastic locking device until it "clicks" and is firmly in place. Repeat on both sides.
7.7b) WARNING Always check that the seat fabrics fabrics is properly attached on both sides.
Make sure that the 4 plastic sticks are correctly assemblied all the way through the end so that it carries the fabric
and that all the 4 plastic stick handles are correctly and securely "clicked" onto the frames opening. Make sure that
the seat fabrics 2 openings are correctly pulled over the 2 buttons screwed on the frame. Control this on both sides.
Control and make sure that the fabric locking plastic part is pressed towards the foot end (opposite direction of the
handle where the seat units angle is adjusted) and pushed in until it "clicks" and is firmly in place so that is securely
holds the seat fabric in place. Control this on both sides. Control all of this every time the seat unit is assemblied.
This is very important!
7.8 Click on the hood with the black fastening devices/hooks. Repeat on both sides.
WARNING Keep hands and fingers away when attaching the hood. Risk of crushing!
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
WARNING The hood must always be assembled correctly when the pram is in use.
7.9 Press the 2 press studs into place. Make sure that the "male" stud goes down under the frame.
Repeat on both sides.
7.10 Zip on the hood. Close the zipper between the hood and the seat unit. Make sure the zip is closed all the way.
WARNING The hood must always be assembled when the pram is in use.
7.11 Pull the hood fabric down under the frame until it sits tightly secured. Pull the fabric over the seat recline handle.
7.12 Insert the bumper bar into the brackets on both sides of the seat until you hear a "click".
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
WARNING Keep hands and fingers away when attaching the hood. Risk of crushing!
7.13 The silver button shall be fully visible when correctly inserted (as illustrated on picture 7.13).
WARNING Always check before use that the bumper bar is firmly in place
7.14 Press the two studs together around the bumper bar until its firmly attached.
WARNING The bumper bar should always be assembled when using the seat unit.
WARNING Always check before use that the bumper bar is firmly in place
WARNING NEVER carry the pram/seat unit/pram body using the bumper bar. This is very important!
7.15 For the Seat Unit, always use the shorter adaptors attached to the chassis, (as illustrated on picture 7.15).
WARNING Never use the longer adaptors with the seat unit!
7.16 Attach the shorter adaptors to the chassis by pressing the silver button and sliding in the adaptor with a
slight push. Click the adaptors into the chassis, make sure it clicks in properly and securely.
Repeat on both sides.
WARNING Keep hands and fingers away when attaching the adaptors. Risk of crushing!
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
WARNING Always check that the adaptors are properly fixed firmly to the chassis before the pram is used.
7.17 This is how the adaptor looks when correctly assemblied on the chassis (as illustrated in the picture 7.17)
Teutonia TRIO, v.1.1
43