Power Source
Temperature
Operating conditions
Humidity
Weight
External dimensions (W x H x D)
*1 Not for use with a generic DC power supply device.
*2 "Power consumption coefficient" is a coefficient to calculate the relative power consumption of the
devices that receive power through the M-NET transmission cable.
Refer to section 4 "System diagram" in Chapter 1 in this Manual.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specifications
17-32 VDC *1
(for connection to M-NET only)
Operating temperature range
Storage temperature range
20%–90% RH (Non-condensing)
0.3 kg (11/16 lbs)
140 x 120 (123) x 25 (28.8) mm
5-17/32 x 4-3/4 (4-27/32) x 1 (1-5/32) in
* The numbers in the parenthesis indicate the dimensions including the protruding
parts.
– 22 –
Receives power from outdoor units via the M-NET
transmission cable. The power consumption
2
coefficient*
of the Smart ME Controller is "0.5".
0ºC – +40ºC (+32ºF – +104ºF)
-20ºC – +60ºC (-4ºF – +140ºF)