6159933610_05
Series: A
1.5 - Tool use hazards
There is a real burning risk when in contact with
the accessible parts of the tool. The selection of
the tool and of the controller takes account of the
operating conditions as stated by the user, who
shall not exceed the operating limits as specified
by the manufacturer at the time of the selection.
Do not force tool. Use the correct tool for your
application. The correct tool will do the job better
and safer at the rate for which it is designed.
Do not use tool if switch doesn't turn it on or off:
any tool that cannot be controlled with the switch
is dangerous and must be repaired.
Disconnect the plug from power source before
making any adjustments, changing accessories
or storing the tool. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
Store idle tools out of reach of children and other
untrained persons. Tools are dangerous in the
hands of untrained persons.
Check for misalignment or binding of moving
parts, breakage of parts, and any other condition
that may affect the tools operation. If damaged,
have the tool serviced before using. Many
accidents are caused by poorly maintained tools.
Use only accessories that are recommended by
the manufacturer for your model. Accessories
that may be suitable for one tool may become
hazardous when used on another one.
1.6 - Tool care and service
Tool service must be performed only by qualified
repair personnel. Service or maintenance
performed by unqualified personnel could result
in a risk of injury.
Only experienced and qualified personnel
(authorised electricians) are entitled to open and
have access to the inside of the controller. To
eliminate the risk of electric shock, the inside of
the controller shall not be serviced until at least
one minute has elapsed after switching off the
controller.
In order to eliminate the risk of electric shock and
damage to components, the controller MUST be
switched off prior to any tool change.
When servicing a tool, use only identical
replacement parts. Use of unauthorised parts or
failure to follow Maintenance instructions may
create a risk of electric shock injury.
2 - DECLARATION OF USE
Controller to be used exclusively with SLB
electric screwdrivers. No other use will be
permitted. For professional use only.
To reduce risks of accidents, any
person who uses, installs or repairs
this tool, changes the accessories
or works in its proximity should read
these instructions beforehand.
This module should be grounded.
Do not use this module in explosive
atmospheres.
Do not use the module without its
protections.
2.1 - Operation features
Input voltage
Downstream output
voltage
Power consumption 220W
Duty cycle
Suitable model (For
one power supply)
2.2 - Dimensions
2.4 kg
(5.29 lb)
E S P 1
- A
O N
C le ar
R es et
6 / 228
English
100-240VAC / 50-60 Hz
40 / 32 / 24VDC
5.5A
On 1 sec / Off 3 sec
SLB003, SLB012,
SLB020, SLB030,
SLB050
24 V
32 V
40 V
02/2017