Black and Decker HP9048 Manual Del Usuario página 6

ENGLISH
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.

Do not expose the battery to water.

Do not store in locations where the temperature may

exceed 40 °C.
Charge only at ambient temperatures between 10 °C and

40 °C.
Charge only using the charger provided with the tool.

When disposing of batteries, follow the instructions given

p in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your Black & Decker charger only to charge the

battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.

Have defective cords replaced immediately.

Do not expose the charger to water.

Do not open the charger.

$
Do not probe the charger.

+
The charger is intended for indoor use only.
- Read the instruction manual before use.
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
will resume operating.
Charge only at ambient temperatures between
10 °C and 40 °C.
y
Charging process completed
Charging
6
Electrical safety
#
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Forward/reverse switch
2. Head adjustment button
3. Operating mode selector
4. Torque adjustment collar
5. Bit holder sleeve
6. LED
7. Bit storage
8. Tape measure
Fig. A
9. Charger connector
10. Charger
11. Charger plug
Assembly
Fitting and removing a drill bit or screwdriver bit
(fig. B)
This tool uses screwdriver bits and drill bits with a 1/4" (6.35 mm)
hexagonal shank.
Pull back the bit holder sleeve (5).

Insert the bit shaft (12) into the bit holder.

Release the bit holder sleeve.

Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery (fig. A)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before. When charging the battery for the first
time, or after prolonged storage, it will only accept an 80%
charge. After several charge and discharge cycles, the battery
will attain full capacity. The battery may become warm while
charging; this is normal and does not indicate a problem.