Backrest Adjustment; Shoulder Adjustment - ISRI 6860 NTS2 Manual De Instrucciones

For your safety, and for the safety of other drivers, the seat can only be adjusted while seated and when
the vehicle is fully stopped and the hand brake is pulled.
22
INSTRUCTION MANUAL ISRI 6860/875

Backrest Adjustment

13
The backrest adjustment is needed to enable the driver an upright posture for
having a good view to the traffic.
Press your back slightly against the backrest. Pull handle completely over the
full adjustment stroke and adjust the backrest to the desired inclination by mo-
ving your back for- or rearwards.
The distance from the back of the head to the backrest should be kept as low
as possible by a steeply adjusted backrest.
Don`t drive wtih a too much backwads folded backrest - this also applies to
the passenger - in order to avoid the risk of sliding out of the belt during a full
brake situation.
Adjust the backrest to an inclination where the steering wheel can be reached
with angled arms.
Adjust the backrest only when sitting, otherwise the backrest moves forward
quickly.
Don't fold the backrest completely down to the seat cushion with force, in order
to preserve the backrest's side bolsters.
Don't sit or place anything on a backrest while folded down.
A folded down backrests shall not be used as a method of ascent while ente-
ring the vehicle.
After backrest adjustment readjust shoulder adaption and belt hight adjust-
ment.
The Backrest must not touch the cabin wall after adjustment.

Shoulder Adjustment

14
The shoulder adjustment enables a full flat contact with the backrest by inclina-
tion adjustment of the upper Backrest area.
This adjustment allows an individually adaption of the seat to the length of the
upper body.
Push switch and adjust the upper backrest area in the desired position.
The distance from the back of the head to the backrest should be kept as low
as possible.
The adjustment of the shoulder adaption must be matched to backrest inclina-
tion and belt height adjustment.