Working Advice; Maintenance And Service; Maintenance And Cleaning - BTI SB 1100 E Manual Original

Working Advice

Apply the power tool to the screw/nut only
when it is switched off. Rotating tool inserts can
slip off.
Tips
After longer periods of working at low speed, allow
the machine to cool down by running it for approx.
3 minutes at maximum speed with no load.
For drilling in tiles, set the selector switch 2 to the
"Drilling" symbol. Do not switch over to the symbol
"Impact Drilling" or work with impact until after drilling
through the tile.
Use carbide tipped drill bits when working in con-
crete, masonry and brick wall.
For drilling in metal, use only perfectly sharpened HSS
drill bits (HSS=high-speed steel). The appropriate
quality is guaranteed by the BTI accessories program.
Twist drills from 2.5–10 mm can easily be sharpened
with the drill bit sharpener (see accessories).

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for BTI
power tools.
In all correspondence and spare parts orders, please
always include the 7-digit order number given on the
nameplate of the machine.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must be
collected separately and disposed of
in an environmentally correct manner.
Subject to change without notice.
30 | English
2 609 932 785 • 28.9.10