Revell Control Moovee Manual De Instrucciones página 10

Problem:
The rotor blades do not move.
Problem:
The helicopter stops for no clear
reason during flight and drops.
Problem:
The helicopter cannot be
controlled.
Problem:
The helicopter only pivots on its
own axis to the left or right.
You can find further tips and tricks on the Internet at www.revell-control.de.
At www.revell-control.de, you can find our possibilities to order,
replacement tips for spare parts, and further useful information
10
resolution of errors Safety Tips
cause:
• The ON/OFF switch is set to "OFF".
• The battery is too low or empty.
• The helicopter is not ready.
cause:
• The battery is too low.
• The infrared connection is being disturbed
(e.g. excessively bright lighting).
cause:
• Another infrared source is disturbing the
signal transmission.
• The signal transmission is disturbed due to
bright light irradiation.
cause:
• Trimming too extreme to the right or left,
e.g. due to incorrect, permanent pressing on
the trim buttons
Service guidelines
on all revell control models.
remedy:
• Set the ON/OFF switch to "ON".
• Charge the battery.
• Set the actuating regulator to full and back to
zero and wait for 5 seconds.
remedy:
• Charge the battery.
• Secure the infrared connection; change the
location if necessary.
remedy:
• Avoid possible infrared disturbance sources
or switch them off.
• Use the helicopter in a different location.
remedy:
• Reset the trimming by repeated, brief taps
on the trim buttons for the opposite direction
(see Page 8)
www.revell-control.de