Testing With Blood Sample; Preparing The Lancing Device - Fora 6 GTel Manual De Instrucciones

Testing With Blood Sample

Test Strip Appearance
Absorbent Hole
Apply a drop of blood
here. The blood will be
automatically absorbed.
Test Strip Handle
Hold this part to insert
the test strip into the slot.
Confirmation Window
This is where you confirm
if enough blood has been
applied to the absorbent
hole in the strip.
Contact Bars
Insert this end of the test
strip into the meter. Push it
in firmly until it will go no
further.
1. Blood Glucose
2. β-Ketone
3. Total Cholesterol
4. Uric Acid
Inserting a Test Strip
Insert the test strip into its slot.
Important!
The front side of test strip should face up when inserting the
test strip. Test results might be wrong if the contact bar is not
fully inserted into the test slot.
Important!
To reduce the chance of infection:
• Never share a lancet or a lancing device.
• Always use a new, sterile lancet. Lancets are for single use
only.
• Avoid getting hand lotion, oils, dirt, or debris in or on the
lancets and the lancing device.

Preparing the Lancing Device

1. Remove the cap.
2. Insert a new lancet firmly into the white lancet holder cup.
EN-7