Use And Care - Homewerks Worldwide HTR-REV02-L Manual Del Usuario

Model #HTR-REV02-L
www.homewerksww.com
All manuals and user guides at all-guides.com
Instructions
USE AND CARE
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE SERVICING
THE UNIT.
TO REPLACE BULB – Remove lens by gently depressing sides and pull down. Use bulb rated up
to 60 watts only.
CAUTION: ALLOW BULBS TO COOL BEFORE REPLACING.
TO CLEAN LENS AND GRILLE – Remove lens as explained above. Remove bulb. Remove screw in
center of reflector and lower assembly.
CAUTION: G rille and reflector are separate units. Unplug light from receptacle. Plastic parts
can be cleaned with mild, soapy water and dried with soft cloth.
DO NOT USE ABRASIVE CLOTHS, STEEL WOOL PADS, OR SCOURING POWDERS. NEVER USE SOLVENTS,
THINNER OR HARSH CHEMICALS FOR CLEANING THE FAN.
TO CLEAN FAN ASSEMBLY – Unplug fan motor cord from receptacle. Remove retaining screws.
Gently vacuum fan, motor and interior housing. Motor is permanently lubricated and never needs
oiling.
CAUTION: F an and motor will swing downward when screw is removed. Support this unit
with free hand while removing retaining screw.
TO CLEAN HEATER ASSEMBLY – Unplug heater cord from receptacle. Loosen retaining screws. Place
a screwdriver tip between outer wall of housing and heater exhaust opening. Gently pry outward
until exhaust housing slips off support tip. Gently vacuum fan, motor and interior housing. Motor
is permanently lubricated and never needs oiling.
CAUTION: U nit will swing downward when released. Support with free hand while prying
with screwdriver.
METAL AND ELECTRICAL PARTS SHOULD NEVER BE IMMERSED IN WATER.
Item# 398999
9
Effective/Rev. date: March 15, 2012