Chronograph Operation - Timberland VD53 Manual Del Usuario

Size: 170 x 55mm
Color: Blk

CHRONOGRAPH OPERATION:

The chronograph can measure up to 1 hours in one
CHRONO 24 HOUR
second increments. Pusher A starts and stops the
MINUTE HAND
chrono operation. Pusher B is for reset.
To measure elapsed or split time:
1. PRESS pusher A to start timing
2. PRESS pusher B to stop timing. The stopwatch
A
continues to count seconds
elapsed but the hands do not move.
3. PRESS pusher B again to resume timing.
The hands move quickly to indicate elapsed time
and continue counting.
NOTE: The hour, minute and second hands on the
B
watch will continue to indicate
the correct time while using the stopwatch.
CHRONO
SECOND
Size: 85 x 55mm
Color: Blk
TIME SETTING:
1. Pull crown out to position 3.
2. Turn the crown to set the desired time.
3. Return the crown to its normal position
DATE SETTING:
1. Pull the crown out to position 2
2. Turn the crown counter-clockwise until the correct
date is shown in the date window.
SECOND
* do not set the date between 9:00 p.m. and
3:00 a.m.
3. Return the crown to its normal position.
24-HOUR SUB-DIAL SETTING:
The 24-hour hand moves correspondingly with the
hour and minute hands. When setting the time be sure
to check that the 24-hour hand is set properly.
ADJUSTING THE CHRONOGRAPH:
1. Pull the crown to position 3.
2. Press A to reset the chronograph second hand to
zero.
3. Press B to reset the chronograph minute and hour
hands.
4. Reset the watch to the current time and return the
crown to its normal position.