Time Setting; Chronograph Operation - Timberland VD50 Manual De Instrucciones

CHRONOGRAPH OPERATION:

* The measurement time is indicated by the
stopwatch hands that move independently of the
center hands.
* The stopwatch can measure up to 60 minutes.
CHRONO 1/10
* The stopwatch measures in 1/10 second
SECOND
increments.
To measure elapsed or split time:
1. PRESS pusher A to start timing
2. PRESS pusher B to stop timing. The stopwatch
CHRONO
continues to count seconds elapsed but the hands
MINUTE
do not move.
3. PRESS pusher B again to resume timing. The
hands move quickly to indicate elapsed time and
continue counting.
CHRONO
NOTE: The hour, minute and second hands on the
SECOND
watch will continue to indicate the correct time
while using the stopwatch.
The stopwatch 1/10 second hand moves for a first
minute. After one minute, it indicates the
measurement time when it is stopped.

TIME SETTING:

1. Pull crown out to position 3.
2. Turn the crown to set the desired time.
3. Return the crown to its normal position.
DATE SETTING:
1. Pull the crown out to position 2.
2. Turn the crown counter-clockwise until the
correct date is shown in the date window.
SECOND
* do not set the date between 9:00 p.m. and
3:00 a.m.
3. Return the crown to its normal position.
ADJUSTING THE CHRONOGRAPH:
1. Pull the crown to position 3.
2. Press button A or B to reset all stopwatch hands to "0" position.
* The stopwatch minute hand moves correspondingly with the
stopwatch second.
* The hands move quickly if the respective buttons are kept pressed.
3. Reset the watch to the current time and return the crown to its
normal position.