Dentsply Maillefer propex pixi Manual Del Usuario página 159

Guidance and manufacturer's declaration - electromagnetic emissions
The Product is intended for use in the electromagnetic environment specified below. The customer or the user of the
Product should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/flicker emissions
IEC 61000-3-3
Guidance and manufacturer's declaration - electromagnetic immunity
The Product is intended for use in the electromagnetic environment specified below. The customer or the user of the
Product should assure that it is used in such an environment.
Immunity tests
Electrostatic dis- +/- 6 kV contact
charge (ESD)
+/- 8 kV air
IEC 61000-4-2
Power frequency 3 A/m
(50/60Hz) magnetic
field
IEC 61000-4-8
Note: UT is the a.c. mains voltage prior to application of the test level.
Guidance and manufacturer's declaration - electromagnetic immunity for not life
The Product is intended for use in the electromagnetic environment specified below. The customer or the user of the
Product should assure that it is used in such an environment.
Immunity IEC 60601
tests Test level
Radiated 3 V/m
RF 80 MHz to 2.5
IEC 61000- GHz
4-3
Compliance
Group 1
Class B
Not applicable
Not applicable
IEC 60601 Compliance level
Test level
+/- 6 kV contact
+/- 8 kV air
www.enversaltan.com
3 A/m
support equipment
Compliance
level
Portable and mobile RF communications equipment should be
used no closer to any part of the Product, including cables, than
the recommended separation distance calculated from the equation
applicable to the frequency of the transmitter.
Recommended separation distance:
3 V/m
80 MHz to d = 0,35
2.5 GHz
d = 0,7
159
Electromagnetic environment -
The Product uses RF energy only for
its internal function. Therefore, its
RF emissions are very low and are
not likely to cause any interference in
nearby electronic equipment.
The Product is suitable for use in all
establishments, including domestic esta-
blishments and those directly connected
to the public low-voltage power supply
network that supplies buildings used for
domestic purposes.
Electromagnetic environment -
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
should be at least 30 %.
Power frequency magnetic fields should
be at levels characteristic of a typical
location in a typical commercial or
hospital environment.
Electromagnetic environment - guidance
P
80 MHz to 800 MHz
P
800 MHz to 2,5 GHz
guidance
guidance