Troubleshooting - Steinbach Twin Manual Original

Troubleshooting

Fault description
1H+1.5H blink and a signal
sounds
1.5H+2H blink and a signal
sounds
1H+2H blink and a signal
sounds
The cable is twisted or tangled. The cable was not completely
The device cannot reach all
spots.
Cause
The pump is overloaded.
The drive motor is overloaded. Check the drive belt.
The device is out of the water.
detached.
The cable in the water is too
long.
The device becomes stuck on
the drain grate.
The control unit was wrongly
positioned.
The water circulation of the
pool is switched on.
The cable is too short.
Remedy
Stop the device and check if
the wheel is blocked by a
foreign object.
Stop the device, immerse it in
water and start the device
again.
Switch off the device,
disconnect the cable and
untangle it.
Pull the excess cable length out
of the water. The cable in the
water should only be long
enough so that the device can
reach all spots in the pool.
Switch off the filter system of
the pool.
Position the control unit so
that the device can easily
access all spots.
Switch off the filter system of
the pool.
Let a sufficient length of cable
into the pool so that the device
can reach all spots in the pool.
Observe the minimum
distance of the control unit to
the pool.
43