Technical Data; Filling The Magazine; Noise/Vibration Information - KMR 3484 Manual Del Usuario

4 I English
1

TECHNICAL DATA

Type
Dimensions mm
Weight kg (without fasteners)
Single sequential or contact actuation
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity.
(No. of fasteners)
Penetration depth setting
Lighting
Fasteners: DA brad nails
DA brad length mm
Wire thickness mm
Recommended lubricant
1 litre special oil. Code No.
250 cm3 grasa especial. Code No.
2

NOISE/VIBRATION INFORMATION

Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level
L WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a)
The noise level when working can exceed 85
dB (A). Wear ear protection!
* Measured values determined according to
EN 12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
3 SUPPLIED WITH
1 DA Brad nailer
1 Tool use and safety instructions
1 Technical data sheet
1 Transport case
KMR
4
3484
Only those fasteners specified under technical data
(see 1) may be used.
308/322
When filling the magazine, hold the tool so that the
1.83 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
5 - 8 bar /
yoke or trigger depressed.
0.5 - 0.8 MPa
Pull the pusher (l) back until it locks into place. Push
the nail strip into the magazine from the back until it
8 bar / 0.8 MPa
touches the pusher at the front. Release the pusher by
1.4 l at
pressing the button (n), it then pushes the nail strip
7 bar / 0.7 MPa
into the working position.
110
5
yes
yes
The penetration depth of the nail head is adjusted
using air pressure. Should this not suffice, a more
exact setting of the penetration depth can be achieved
25 - 64
by turning the setting nut (p).
1.8
Right-hand turn (U) = less penetration depth.
Left-hand turn (D) = more penetration depth.
9 4420
68 3868
6
-SINGLE TRIGGER RELEASE/RELEASE ON CONTACT-
A setting wheel on the trigger (s) can be turned to set
the type of actuation either to single trigger release
or release on contact (see symbol).
3484
7
83.4 dB(A)
Balancer for 10 - 20 N (1.0 - 2.0 kp),
96.4 dB(A)
cable travel 1.6 m (5.2 ft).
2
3.87 m/s

FILLING THE MAGAZINE

FIL PENETRATION DEPTH SETTING
SWITCHABLE ACTUATION
ACCESSORIES
3484
Code No.
40 3393