Peg-Perego carrello futura Instrucciones De Uso página 11

_ WARNING To avoid injury
ensure that the child is kept
away when unfolding and
folding this product.
_ WARNING Do not let the child
play with this product. This
product is not a toy.
_ WARNING The assembly and
preparation of the product must be
carried out by an adult.
_ Do not use this product if there are
parts missing or signs of breakage.
_ WARNING Never leave the child
unattended.
_ Always apply the brake when
stationary and when loading or
unloading children.
_ Do not insert fingers into the
mechanisms.
_ Be careful not to hurt the child
when adjusting the mechanisms
(handlebar, backrest ... ).
_ Any load applied to the handle and/
or the backrest and/or laterally to
the product can compromise the
stability of the product.
_ Do not load the baskets over 7
Kg. Do not put weight in the cup
holder (if present) in excess of
those indicated on the cup holders
themselves and never hot drinks. Do
not put loads of more than 0.2 Kg in
the hood pockets (if present).
_ Do not use the product near to
stairs or steps, heat sources, naked
flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or
recommended by the manufacturer/
distributor shall be used.
_ WARNING This product is not
suitable for running or skating.
_ WARNING Do not add any mattress
are not approved by the manufacturer.
_ Do not use accessories which are
not approved by the manufacturer.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website:
www.pegperego.com
INSTRUCTIONS
1 OPENING: Before opening the frame, remove (without
using blades) any die-cut cardboard.
WARNING:
_ DO NOT PULL OR FORCE THE FASTENER BEYOND ITS
LIMIT.
_ DO NOT USE THE FASTENER AS A CARRY HANDLE OR
TO CARRY WEIGHTS.
DO NOT HANG BAGS OR OTHER ACCESSORIES TO THIS
FEATURE.
Press down the side fastener, hold the upper section of
the handle and rotate it towards you until the frame is fully
opened (fig_a). Open frame (fig_b).
The frame is properly opened when the attachment on the
base clicks into place, as shown.
WARNING: When placing the seat on the frame, press the
seat downwards to ensure it engages securely onto the base.
2 FITTING THE WHEELS: Slot the uprights into the rear
wheel crosspiece (fig_a), ensuring that it is facing the
right way, then push the rear wheels on and make
sure that they click into place (fig_b). To mount the
front wheels, fit them into the uprights until they lock into
place (fig_c).
3 ATTACHING THE MAIN HANDLE: if the handle tube
faces upwards, align it with the stroller (Fig_a).
Fasten the handle to the frame as shown in the figure
(Fig_b).
To complete the operation, press the two side buttons
on the handle (Fig_c) to ensure the handle pushes in
all the way, until it clicks into place (Fig_d).
4 Fasten the basket eyelets to the buttons on each side
of the frame (fig_1).
To complete the basket attachment procedure for the
front part, you are required to insert the supplied tie
(fig_2) as follows:
position it between the basket and buttons, as shown
(fig_3) and use your finger to push downwards, so as
to complete the attachment procedure (fig_(fig_4).
Repeat the same procedure for the other side of the
basket.
5 Attaching the rear part of the basket.
Fasten the upper basket eyelet to the button on each
side of the frame (Fig_5).
Fasten the basket's two lower eyelets to the two
buttons on the rear bar of the frame (Fig_6).
WARNING: If you do not hook the basket on
correctly, as shown, the basket will be unable to
support the weight of loads placed in it.
6 FIXED OR SWIVELING FRONT WHEELS: Lift the levers
to prevent the wheels from swiveling (fig_a) and
lower them to allow the wheels to swivel (fig_b). On
uneven surfaces, the wheels should be set to their
fixed position.
7 BRAKE: Press the lever down to apply the brake on the
chassis and lift it to release the brake.
8 ADJUSTABLE HANDLEBAR: To adjust the height of the
handlebar, press both of the side buttons at the same
time (fig_a) and swing it into the desired position
(fig_b), then release the buttons.
9 FOLDING UP: The chassis can be folded up without the
seat, with the seat facing the person pushing (recline
the backrest before folding it) or with the seat facing
forward. To fold the stroller, it is best to set the front
wheels to their fixed position and close the hood (if
fitted). Place the handle as shown in the figure (fig_a).
Pull the inside handle on the base (fig_b) and lift it (fig_c);
the handle will drop forward until the frame is closed.
10 To ensure the frame is closed properly, check that
the side fastener is enabled (fig_a). When closed, the
frame remains in the upright position (fig_b).
11 For greater compactness, it is possible to remove the wheels.
To remove the rear wheels: pull outwards on the lever
located under the rear bar and remove the wheels as
shown in figure (fig_a).
To remove the front wheels: press the tab as shown, and
- 11 -