Defrosting, Cleaning And Maintenance; Automatic Defrosting - Blomberg WSN 1412 LT Instrucciones Para El Uso

Defrosting, cleaning and maintenance

Automatic defrosting

The wine cooler is defrosted automatically. Defrost water runs through a pipe
and is collected in a tray above the compressor where the heat generated by
the compressor causes it to evaporate. The defrost water tray should be
cleaned at intervals.
Cleaning
Before cleaning the appliance, unplug it from the main supply. The cabinet is
best cleaned using warm water (max. 65°C) with a little mild detergent. Never
use cleaning agents that scour. Use a soft cloth. Rinse with clean water and
dry thoroughly. The defrost water channel, in which condensation from the
evaporator runs, is located at the bottom of the rear inside wall of the cabinet
and must be kept clean. Add a few drops of disinfectant, e.g. Rodalon, to the
defrost water drain a couple of times a year, and clean the drain using a pipe
cleaner or similar. Never use sharp or pointed implements. The sealing strip
around the door must be cleaned regularly to prevent discolouration and
prolong service life. Use clean water. After cleaning the sealing strip, check
that it continues to provide a tight seal. Dust collecting on the condenser on
the rear of the cabinet, the compressor and in the compressor compartment
is best removed using a vacuum cleaner.
Replacing the light tube
Before replacing the light tube,
unplug the appliance from the main
supply. Remove the lamp cover
using a small flat-headed
screwdriver. Replace the PLC tube
(11 W). Refit the lamp cover,
reconnect the power supply and
start the appliance by pressing the
on/off switch.
Fig. 10
11