Cleaning And Maintenance - QUIETON Q1 Guia Del Usuario

QuietOn_userguide_2017_90x90_EN_13122017.pdf 5 13.12.2017 10:36:10
3.2 EARTIP SELECTION
Three di erent eartip sizes are provided with the product - small green silicone: 12.1 mm, medium blue
silicone: 13.3 mm; and medium black foam: 12.5 mm. It is recommended that earplugs are fitted,
adjusted and maintained in accordance with the following instructions.
Ensure that it is small enough to penetrate the ear canal and provide a secure fit, but is also large
enough that at least two flanges of silicone tips seal the ear canal. In case of foam tip ensure that it
seals the ear canal completely. If the medium size does not provide a proper fit, proceed with the
small or large size eartips as these were designed to fit users for whom the medium size is not
suitable. Do not use product if the proper size and fit cannot be obtained.
Use only QuietOn eartips designed for use with this product. Di erent tip sizes are available via
QuietOn webshop to help you the ensure that plugs will fit airtight in your ears. Do not insert the
earpiece directly into the ear without correctly attaching it to QuietOn earplug. In order to be
comfortable to use, tips are designed and manufactured of soft material and are not under warranty.
Lifetime of Comply foam tips is some months depending on the usage, new ones can be aquired from
Quieton webshop.
3.3 STORAGE
QuietOn earplugs should be stored in charging case. Please refer to the storage temperature ranges
listed in the "Temperature ranges" section. Batteries are fully charged at the factory, they will
self-discharge gradually like all batteries. To keep batteries in good condition while in storage, it is
recommended to recharge the earplugs once every four months.

4 CLEANING AND MAINTENANCE

4.1 CLEANING THE QUIETON EARPLUGS
It is important to clean the device to maintain its functionality. To maintain the performance of your
QuietOns, ensure also that your ears are clean before using the earplugs. The body of the earplug can
be cleaned with a dry or damp cloth. Avoid touching the mesh at the end of the audio canal.