How To Adjust The Feeding Hopper; How To Open The Note Transport Path - Hilton Europe Beeplo b6100 Manual De Usuario

Double notes
Chained notes
Image error
Silver error
Paper error
Spectrum error
Denomination
different
Blocking error

7.3 How to adjust the feeding hopper

The position of the hopper adjusting screw has already been set to the best position in the
factory. When unnecessary counting errors occur (i.e. Double notes/Chained notes), it need
to adjust the adjusting screw to optimize the banknote transport.
When the banknotes can not be counted smoothly, increase the distance.
When the machine stops and displays the codes "Double notes" or "Chained notes",
decrease the distance.
Use the straight screwdriver to adjust the adjusting screw and turn the screw clockwise to
decrease the note thickness distance, turn the screw counter-clockwise to increase the
distance. The adjustment screw is very sensitive, make only minor adjustments.
Counter-clockwise to increase
the note thickness distance

7.4 How to open the note transport path

When the machine displays the self test error or detective error message, usually it is
because the sensor is blocked by banknotes or dusts. Press the handle up to open the note
transport path, then remove the banknote and clear away the dusts (see the figure below).
Some banknotes are connected or overlapped ， put the
banknotes on the banknote stacker back to the banknote
hopper to count again. If it is often displayed, adjust adjusting
screw toward the clockwise direction
Counterfeit or suspicious banknote, remove
"RESET" to continue counting.
Close the note transport path and remove the banknote and
clear away the dusts
Remove suspect notes, remove counted notes and re-count
Press "RESET" key, or press the handle up to open the note
transport path, then remove the banknote and clear away the
dusts
Clockwise to decrease the
note thickness distance
14
it and press