Functional Description Of The Equipment; Tips And Needles Kits - Sagola Mini XTREME Manual De Instrucciones

24/25
· If sagging occurs, this is due to the fact that the amount of product to be applied is excessive
for the air pressure used, that the viscosity is not correct or the application speed is not
adequate. Decrease the amount of product, adjust its viscosity or increase the application
speed until the required finish is obtained.
· The spraying width (spraying pattern) obtained will depend on the air nozzle used. If nozzles
are required for other applications, contact the SAGOLA S.A. Technical Service.
· The size or amplitude of the spraying pattern can be modified with the spray width regulator,
by turning the control anticlockwise to increase this or clockwise to reduce this.

7. Functional Description of the Equipment

The SAGOLA MINIXTREME gun in its two versions (Gravity or Pressure) can be used for applying
appropriately diluted products (paints, lacquers, varnishes, adhesives, etc.), used widely in the
automotive industry, timber industry, plastics, etc.
In the Gravity version, compressed air for spraying is connected to the air input connector under
the gun grip.
The product to be applied is placed in the cup provided for this purpose, from which it flows by
gravity to the fluid tip and is then mixed with spraying air in a way that can be controlled from
outside the air nozzle.
In the Pressure version, compressed air for spraying is connected to the air input connector
under the gun grip.
The product to be applied is placed in the pressure tank (hereinafter Reboiler) or using a
pressure pump. From here it flows through a hose to the fluid tip and is then mixed with spraying
air in a way that can be controlled from outside the air nozzle.
When the trigger is pulled back to the first position, it engages the air valve stem, opening this
and allowing air to flow through.
When the trigger is pulled back fully, the product needle is retracted, allowing the product to
flow out. This is then sprayed in the form of a fan.
When the trigger is released, the needle returns to its initial position, first closing off the product
outlet and then the air valve and application stops.

8. Tips and Needles Kits

SAGOLA S.A. supplies Nozzle Kits and Tip and Needle Kits of
different sizes for a variety of different applications. In order
to replace these, proceed as follows:
With the gun fully depressurised, remove the air nozzle.
Remove the product regulator with the spring and the spring
stop and extract the needle to be replaced. Remove the tip
with the wrench supplied.
Fit the new tip and tighten it. Now fit, in this order, the new
needle, the spring and spring stop and the product regulator.
Lastly, fit the appropriate air nozzle.
There are Tip + needle Kits for this model of Ø 0.80, 1.00, 1.20, 1.30 and 1.40.
ENGLISH