Enviracaire EWM-211D Manual De Instrucciones página 9

CHANGING THE UV BULB
1. If the "REPLACE UV BULB" indicator illuminates during normal use, it is time
to change the UV bulb, which is a special 3.5W bulb.
2. Press "POWER/MODE" touch switch to the "OFF" position, unplug it and
allow it to cool.
3. Remove the water tank from the base of the
humidifier.
4. Place the base of the humidifier over the sink
and tilt the unit to remove any remaining
water.
5. Carefully turn the base of the humidifier over
and place it upside down on a flat level sur-
face. You will see a door that is closed with
a screw.
6. Using a Phillips head screwdriver, carefully turn the screw(s) counterclock-
wise until the screw(s) separate from the door.
7. Open the door. The UV light bulb will be visible.
8. Take a replacement 3.5W UV bulb that you purchased from Kaz Incorporated
or another supplier and change the bulb. To prolong the life of the bulb, limit
your direct contact with the glass of the bulb by using a cloth or tissue to
screw it into place.
9. When the new bulb is in place, close the door and replace the screw(s) by
using your Phillips head screwdriver and rotating it clockwise until it is just
tight. DO NOT OVER TIGHTEN.
10. DO NOT turn power on, while UV Lamp Door is open, and do not view
illuminated bulb directly because eye damage may occur.
11. Turn the unit upright, place the water tank on top of the base of the
humidifier, plug the unit in, and push "POWER/MODE" touch switch to either
the "HI" or "LO" position. The "REPLACE UV BULB" indicator should no
longer be lit.
IMPORTANT NOTE: Even though you will not receive maximum germicidal
effects, you can still use your humidifier until the replacement bulb arrives.
NOTE: You will hear a rattling sound and notice a small round object inside your
bulb. This is normal. Your bulb is fully operational.
Lamp contains mercury. Manage in accordance with disposal laws.
See www.lamprecycle.org or call 1-800-895-8842
8