InstallatIon oF Panels
After performing all required checks, proceed to
fasten the tub.
The tubs of the manufacturer must be fastened.
The panels are equipped with accessories for fasten-
STRAIGHT PANELS
Screw cover
Spacer
Screw
Washer
Recessed installation on low walls (Fig.5)
Construct the low walls keeping in mind that the
internal volume measurements referred to in the
technical information sheet are purely approxi-
mate. For ordinary maintenance and for adequate
system ventilation an inspection grill must be
mounted on the low walls near the electric pump,
measuring 60x45 (code T260000White; code
T2600AA Chromed code T260067 Can be tiled)
composed of the external grill and a steel frame
which must cemented to the structure of the low
walls where the edges of the tub rest by means of
appropriate clamps.
Before attaching the grill, it is necessary to connect
the frame to the equipotential wire by means of
the appropriate terminal. The positions for this
inspection grill are on the short side or on the
long side but in any case near the electric pump.
The construction of the low wall must in no way
TT0283385_02_SOFT_CMYK.indd 85
(
)
normal tuB
ing (Fig.4). To install the parts, follow the instructions
in the technical information sheet included with
the kit.
Front fastening
Screw cover
Spacer
Screw
Washer
prevent the tub from being extracted for special
maintenance or for replacement.
SHAPED PANELS
Spring fastening
Screw cover
Spacer
Screw
Washer
Fig.4
Fig.5
85 85
5-07-2010 16:34:11