Mongoose Netflix Stranger Things El Manual Del Propietario página 23

❺ Place the top cap onto the top of the steerer tube. Insert
and tighten the top cap bolt until it is snug. Do not tighten
completely at this time. Figure 3.10
❻ Loosen and remove the pinch bolts holding the stem face
plate on the front of the stem.
❼ Apply a bit of grease to the threads of the bolts before
threading them back into the stem.
❽ Insert the handlebar into the stem. Note: use the rough
area of the handlebar to help center them into the stem.
❾ Place the face plate over the handlebar.
❿ Begin threading the pinch bolts into the stem body. Tighten
the pinch bolts in a cross pattern. Do not overtighten the
bolts. As you tighten the bolts the gap between the face
plate and the stem body should be the same all around.
⓫ Look from the side of the bike and check that the handlebar
is parallel with the fork. Figure 3.11
⓬ Look down over the handle and stem and check that the
stem is parallel with the tire. Figure 3.12
⓭ Finish tightening the pinch bolts and stem cap bolt.
Figure 3.10
5
14
11
Figure 3.11
Assembly 3
6
Handlebar
8
(rough area)
3
13
1
2
4
10
Pinch bolts
Face plate
Figure 3.10
12
Figure 3.12
21
21