Operating Instructions; Nose Equipment; Chargers - Stanley NB08PT-18 Manual Del Usuario

4. OPERATING INSTRUCTIONS

Always wear approved hearing and eye protections at all times when using installation
equipment.
WARNING: Before adjusting tool, always remove the battery pack.
4.1

NOSE EQUIPMENT

NB08PT-18 drawing can be found inside the front cover
Mounting the mandrel and nosepiece(fig. 4,5,6)
•
Select the correct mandrel (A) and nosepiece (B) for the blind nut (Y) to be installed. Reference the
Accessories Manual for appropriate nose equipment.
•
Loosen the nose housing nut (E), Remove the nose housing (D).
•
Press the mandrel lock (P), Loosen and remove the mandrel (A).
•
Screw the correct mandrel (A) into Spin Pull Head (R) while pressing the mandrel lock (P). Lock the
mandrel (A)
•
Loosen the lock nut (C) and unscrew and remove the nosepiece (B) and Lock nut (C)
•
Screw the Lock nut (C) onto the correct nosepiece (B) and screw the nosepiece (B) into the nose housing
(D) lightly.
•
Adjust the position of the nosepiece (B) according to the blind nut (Y) to be installed. The length of
mandrel protruding from the top of blind nut (Y) to be 0-0.5mm.
•
Tighten the lock nut (C) by a spanner properly.
4.2

CHARGERS

Your tool uses a DEWALT
requires no adjustment and is designed to be as easy as possible to operate.
Charging Procedure (fig. 2)
•
Plug the charger into an appropriate outlet before inserting the battery pack. (Refer to the Charger
Specifications in Section 2)
•
Insert the battery pack (K) into the charger, making sure the pack is fully seated in the charger. The red
(charging) light will blink continuously indicating that the charging-process has started.
•
The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully
charged and may be used at this time or left in the charger.
NOTE: To ensure maximum performance and life of Li-Ion battery packs, charge the battery pack fully before first use.
Charging Process
Refer to the table below for the state of charge of the battery pack.
Charge indicators:
charging
fully charged
hot/cold pack delay*
*The red light will continue to blink, but a yellow indicator light will be illuminated during this operation. Once
the battery has reached an appropriate temperature, the yellow light will turn off and the charger will resume
the charging procedure.
This charger will not charge a faulty battery pack. The charger will indicate faulty battery by refusing to light.
® charger. Be sure to read all safety instructions before using your charger. The charger
E N G L I S H
17