Stanley FATMAX KFFMED500 Manual De Instrucciones página 5

When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool along with the
date code:
Warning! To reduce the risk of injury, the user
:
must read the instruction manual.
Wear ear protectors with Impact drills. Exposure
f
to noise can cause hearing loss
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
#
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Stanley
Centre in order to avoid a hazard .
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Lock-on button
3. Forward/reverse switch
4. Drilling mode selector
5. Tool holder
6. Side handle
7. Depth stop
8. Depth stop lock button
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting the side handle (fi g. C
Turn the grip counterclockwise until you can slide the side

handle (6) onto the front of the tool.
Rotate the side handle into the desired position.

Tighten the side handle by turning the grip clockwise.

Fitting an accessory (fi g. A)
Clean and grease the shank (9) of the accessory.

Pull back the sleeve (10) and insert the shank into the tool

holder (5).
Push the accessory down and turn it slightly until it fi ts into

the slots.
Pull on the accessory to check if it is properly locked. The

hammering function requires the accessory to be able to
move axially several centimetres when locked in the tool
holder.
To remove the accessory, pull back the sleeve (10) and

pull out the accessory.
Use
Warning! Let the tool work at its own pace. Do not overload.
Warning! Before drilling into walls, fl oors or ceilings, check for
the location of wiring and pipes.
Selecting the operating mode (fi g. B)
The tool can be used in three operating modes. Press in the
button (11) and rotate the drilling mode selector (4) towards
the required position, as indicated by the symbols.
Drilling
For drilling in steel, wood and plastics, set the operating

mode selector (4) to the
FatMax Service
® ®
Hammer drilling
For hammer drilling in masonry and concrete, set the

operating mode selector (4) to the
When hammering, the tool should not bounce and run

smoothly. If necessary, increase the speed.
Hammering
For hammering with spindle lock, and for light chiselling

and chipping, set the operating mode selector (4) to the
q
Make sure the forward/reverse switch is in the forward

position.
When changing from hammer drilling to chiselling, turn

the chisel to the desired position. If resistance is felt
during mode change, slightly turn the chisel to engage the
spindle lock.
When hammering with spindle lock, the angle of the bit

may be changed. Set the operating mode selector (4) to
the
by rotating the tool holder (6). Set the operating mode
selector (4) to the
Selecting the direction of rotation
For drilling, for tightening screws and for chiselling, use for-
ward (clockwise) rotation. For loosening screws or removing
a jammed drill bit, use reverse (counterclockwise) rotation.
(Original instructions)
position.
r
s
position.
position, the angle of the bit may now be changed
position, before continuing.
q
ENGLISH
position
5