Carrier 40VK005S-7S-QEE Manual De Instalación Y Propietario página 15

Installation Procedures
3. Installation diagram of Indoor Units:
more than 15cm
more than
10cm
Arrangement of piping directions
rear left
left
below
(1) Positioning Wall bracket & Locating Wall Holes
Fix the bracket according to the installation location and the pipe layout of indoor unit (please refer to the installa-
tion diagram).
Installation should be done under the crossbeam or on the flat wall near the pillar.
(2) Arranging Wiring of Indoor Unit
Arrange the layout of the connection pipe, drain pipe, connecting line, signal line, and air refreshing pipe accord-
ing to the locations of your indoor unit with drainage hose lower and the connecting line higher. materials for heat
preservation.
rear right
right
lashing wire
drooping piece
positioning
hole
level location
Attention must be paid to
the rising of the drain
more than 10cm
side of indoor
wall hole
cross section of wall hole
place of drooping thread
wall bracket
thread
8
side of outdoor
60 mm
thickness
of wall