Carrier 40VK005S-7S-QEE Manual De Instalación Y Propietario página 18

Installation Procedures
Cutting and enlarging
Cutting or enlarging pipes should be carried
out by installation personnel according to the
operating criterion, if the tube is too long or the
flare opening is broken
Connecting
1. Connecting circular terminals:
The connecting method
of the circular terminal is
shown in the Fig. Remove
the screw, connect it to the
terminal tier after inserting it
through the ring at the end of
the lead and then tighten it.
2.Connecting straight terminals:
The connection method for circular terminals
is shown in the Fig. Loosen the screw before
inserting the line terminal into the terminal tier,
tighten the screw and confirm that it has been
clamped by pulling the line gently.
3.Pressing connecting line:
After line connection is completed, press
the connecting line with clips that should
be pressed on the protective sleeve of the
connecting line.
correct pressing
18 11
Connecting circular
terminals:
wrong pressing