STEP 5
Hang the Filter System Head
1
A
Align the System Head
on the pipes so that the inlet and outlet are in the correct locations. The "in" port on the Filter System should
be facing the incoming water supply.
2
Allow the System Head to temporarily hang between the two cut plumbing pipes.
3
Apply plumber's tape or appropriate sealant to the fittings and lines, according to your system configuration.
4
Make all connections and tighten fittings.
NOTE: Keep the Filter System in an upright position.
A grounding kit (not included) must be installed on water pipes if they are used to ground electrical systems, appliances or phones.
STEP 6
Install the Filter Housing
1
C
Insert the Filter Cartridge
over standpipe in the bottom of the Filter Housing
2
Screw the Filter Housing back onto the System Head and hand-tighten
IMPORTANT: Do not over tighten.
WFPF3800
CAUTION
GROUNDING KIT (NOT INCLUDED)
A.
D.
6
5
IN
A
WATER
FLOW
HOUSE
3
6
C
A
OUT
TO
D
V4.2L