Kit Assembly - Metra DP-7363B Instrucciones De Instalación

ISO DIN radio provision with pocket
1. To remove the factory steering column
cover from the factory dash panel, pry
(4) round retaining clips from where the
leather meets the large panel. (Figure A)
2. Place the leather cover over the Metra
radio trim panel, place the steering
column bracket over the leather and
secure with the (4) #4 x 3/8" Phillips
screws supplied. (Figure B)
3. Mount the pocket to the radio brackets
with the (4) #8 x 3/8" Phillips screws
supplied. (Figure C)
4. Remove the metal "DIN" sleeve and trim
ring from the aftermarket radio.
4

KIT ASSEMBLY

(Figure A)
(Figure B)
5. Slide the radio into the assembly and
secure with screws supplied with the
radio. (Figure D)
6. Locate the factory wiring harness and
antenna plug in the dash and make
all necessary connections to the radio.
Metra recommends using the proper
mating adapters from Metra and/or
AXXESS.
7. Mount the Metra radio assembly into the
dash.
8. Snap the Metra radio trim panel and
steering column cover into the dash and
reassemble the dash in the reverse order
of disassembly.
(Figure C)
(Figure D)
|
1.800.221.0932 MetraOnline.com