Iso Ddin Radio Provision - Metra 99-7010 Instrucciones De Instalación

ISO DDIN radio provision

1. Cut the center bar rib. (Figure A)
2. Slide the appropriate bracket into the kit aligning the
holes in the kit with the holes on the bracket.
3. Slide the radio into the ISO DDIN bracket/radio
housing assembly and secure the radio to the kit
using the screws supplied with the radio. (Figure B)
4. Snap the ISO DDIN trim plate into the kit. (Figure B)
5. Locate the factory wiring harness and antenna
connector in the dash and complete all necessary
connections to the radio and climate controls. Metra
recommends using the proper mating adapter
from Metra and/or AXXESS. Test the radio for proper
operation.
6. Reassemble the dash in reverse order of disassembly.
The World's best kits.
®
KIT ASSEMBLY
Cut center
bar rib
(Figure A)
(Figure B)
MetraOnline.com
I N S TA L L AT I O N I N S T R U C T I O N S
IMPORTANT
If you are having difficulties with the installation of this product,
please call our Tech Support line at 1-800-253-TECH. Before
doing so, look over the instructions a second time, and make
sure the installation was performed exactly as the instructions
are stated. Please have the vehicle apart and ready to perform
troubleshooting steps before calling.
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
99-7010
K P
®
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
REV. 8/22/17 INST99-7010