Kit Assembly; Din Radio Provision With Pocket; Iso Din Radio Provision With Pocket - Metra 99-7010 Instrucciones De Instalación

DIN radio provision with pocket

1. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
2. Slide the sleeve into the kit and secure
by bending the metal locking tabs
down. (Figure A)
3. Slide the radio back into the sleeve until
it clicks in. (Figure B)
4. Snap the pocket into the kit. (Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio and climate controls. Metra
recommends using the proper mating
adapter from Metra and/or AXXESS. Test
the radio for proper operation.
6. Reassemble the dash in reverse order of
disassembly.

KIT ASSEMBLY

(Figure A)
(Figure B)

ISO DIN radio provision with pocket

1. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
2. Secure the ISO brackets to the radio
with the screws supplied with the radio.
(Figure A)
3. Slide the radio into the kit until the side
clips engage.
4. Snap the ISO trim plate into the radio
housing. (Figure B)
5. Snap the pocket into the kit. (Figure B)
6. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio and climate controls. Metra
recommends using the proper mating
adapter from Metra and/or AXXESS. Test
the radio for proper operation.
7. Reassemble the dash in reverse order of
disassembly.
(Figure A)
Right side clip
(Figure B)
REV. 8/22/2017 INST99-7010
3