STACK-ON PWS-1855-E Manual De Instrucciones

PWS-1855-E
Serial #:
Combination:
Battery Disposal
Please dispose the used batteries per municipal or
provincial law.
IMPORTANT
Record the serial number from the tag on the back
of the safe or the tag on the inside of the lock cover
plate on the front of the safe.
Record your combination number.
Keep keys and combination in a secure place away
from children.
DO NOT STORE KEYS OR YOUR COMBINATION
INSIDE SAFE
HARDWARE INCLUDED:
(6) M6 x 50mm (2" long) Lag Screws
(6) Washers
(6) M6 x 40mm (1-1/2" long) Plastic Masonry Anchors
TOOLS REQUIRED:
Drill
Thin Bladed Flat Head Screwdriver
10 mm Wrench
3/16" (5mm) Drill Bit
®
INSTRUCTIONS
GETTING STARTED
When you first receive your new electronic safe
you will need to open the door with the key in
order to install the batteries. Batteries are
included and are located inside the safe.
To open the door with the key, first remove
the lock cover from the front of the faceplate
using a thin bladed flathead screwdriver as
shown. Insert the key and turn Left.
Hold the key in the open position and turn
the knob to the Right to open the door.
NOTE: This key has also been provided in case
you lose or forget your security code or the
batteries run low. If you lose your key, you may
purchase a replacement key by referencing the
serial number located under the removable lock
cover. See the section at the end of these
instructions regarding replacement keys.
Locate the batteries inside the safe. Open the
battery compartment on the back of the door
by pushing the tab in the direction of the arrow
and install the batteries.
NOTE: The reset button located on the
inside of the door, is covered with a
removable cap. When you use the reset
button while setting your own combination,
remove the cap to access the button. Use
the tip of a ballpoint pen or the end tip of a
paper clip to push the reset button.
Replace the cap securely over the reset
button after setting your combination.
Failure to do so will compromise the safety
and security of the safe.
LOCK COVER
40800-1803
1
14