Installing The Led Assembly And Glass Shade - Hinkley COLLIER 54 Manual De Instrucciones

INSTALLING THE LED ASSEMBLY AND GLASS SHADE

NOTE: Be sure the power is off before installing.
Remove one of the three screws on the adapter plate located
1
on the fan motor. Loosen the other 2 screws. (Do not remove)
While holding the LED assembly under your fan, make the
2
polarized plug connections:
- Red to white
- Black to black
Tuck connections neatly into adapter plate. Place the key
3
holes on the LED assembly over the 2 screws previously
loosened, turn the LED assembly until it locks in place at the
narrow section of the key holes. Secure by tightening the 2
screws previously loosened and the one previously removed.
Raise the shade assembly against the adapter plate and secure using
4
the four decorative knobs previously removed
5
Raise the shade assembly against the LED assembly until
snug.
6
Restore power and your LED assembly is ready for operation.
12 | hinkley.com
Wire connectors
LED
assembly
Shade
Assembly
Adapter
Plate
Screws