Publicidad
Idiomas disponibles
Idiomas disponibles
SmarTemp Control 3.0
If the heater has not run 30 days, the preventive maintenance (PM)
reminder will alert the operator with a message to run the heater for 20
minutes. The indicator lights will flash red as a visual reminder.
PM Reminder
The operator will have the ability to Start the 20-minute maintenance cycle
or delay it via a "Snooze" option. When Snooze is selected the PM
reminder will postpone until 12:00PM the following day.
Set time and date using the rotary knob and selection button. 12 (AM / PM)
or 24 hour available.
The Webasto button can be used to go back to the previous field if
Time & Date
additional changes are needed.
NOTE: This must be done before starting the heater for the first time after
power has been applied.
Set intensity of backlight.
Backlight
A password can be set to prevent access to the advanced "Options" menu.
User
Enter a 4-digit code passcode to begin securing the "Options" menu.
Permission
Note: This is typically used in fleet vehicle applications.
Enable or disable Bluetooth functionality.
Bluetooth
This section will log the last 5 error codes and the date that it was set.
Highlight and select an error code for a full description. If the heater
produces an error code, the status indicator lights will flash red and the
error will display on the main screen.
Error Code
NOTE: Heater error codes cannot be reset through the Webasto SmarTemp
Control 3.0; a Webasto PC Diagnostics tool or the SmarTemp app is
required. Refer to the heater service manual for resetting an error code.
When enabled the heater will only start when the parking brake is enabled
Brake Input
and a 12V signal on the Brake Input pin of the SmarTemp 3.0 connector.
Signal
NOTE: This feature is only used in original-equipment applications.
Allows you to name the heater(s) connected to the SmarTemp through the
mobile application after selecting number of heaters. The control method
(analog or W-Bus) to be selected.
Heaters
NOTE: W-Bus is not a control option for the TT Evo heater when used with
an Air Top heater.
Reset to
Returns all settings to factory default values.
Default
Back
Select this to return to the previous screen.
Status Indicator Lights - The Red status indicators (heater "ON") and LCD screen backlight turn off after 30
seconds. A touch of any button or a turn of the rotary knob will re-activate these lights. If the "Webasto"
button is used to re-activate these lights, an additional press of this button is necessary to turn the heater off.
Note that when the heater is "ON" the display is active.
Installation - Operating Instructions
8
ON
80%
Disabled
Enabled
Enabled
N/A
Publicidad
