General Safety Rules - For All Battery Operated Tools; Work Area, Electrical, Personal, General And Specific Safety Rules - Lumax LX-1182 Manual De Instrucciones

GENERAL SAFETY RULES - FOR ALL BATTERY OPERATED TOOLS

 WARNING! FAILURE TO FOLLOW ALL INSTRUCTIONS LISTED BELOW
MAY RESULT IN ELECTRIC SHOCK, FIRE AND/OR SERIOUS PERSONAL INJURY
WORK AREA:
• Keep your work area clean, dry and well lit. Cluttered benches and dark areas invite accidents.
• Do not operate Power Tools in Explosive Atmospheres, such as, in the presence of Flammable
Liquids, Gases, or Dust. Power tools create sparks which may ignite the Dust or Fumes,
particularly, in confined spaces.
• Keep Bystanders, Children, and Visitors away while operating a Power Tool. Distractions can
cause you to lose control. Protect others in the work area from Debris such as Chips and Sparks.
Provide Barriers or Shields, as needed.
ELECTRICAL SAFETY:
• A Battery Operated Tool with Integral Batteries or a separate Battery Pack must be recharged
only with the specified Charger for the Battery. A Charger that may be suitable for one type
of Battery may create a risk of Fire when used with another Battery.
• Use Battery Operated Tool only with specifically designated Battery Pack. Use of any other
Batteries may create a Fire or Explosion.
PERSONAL SAFETY:
• Stay alert! Watch what you are doing. Use common sense when operating a Power Tool.
Do not use Power Tool when tired or under the influence of Drugs, Alcohol, or Medication.
A moment of inattention while operating Power Tools may result in serious personal injury.
• Be aware that your RoboLuber is always in an operating condition, because it does not have to
be plugged into an Electrical Outlet.
• Avoid accidental starting. Prior to inserting Battery Pack or operating the unit, always check to
see that the Trigger-Lock Lever is not in a "flipped-up" position. Carrying tools with your finger on
the switch or inserting the Battery Pack into a Tool with the switch Trigger-Lock Lever in a "flipped-
up" position invites accidents.
• Remove Wrenches before turning the Tool on. A wrench that is left attached to the Tool may
result in personal injury.
• Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing and
gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts.
• Be sure no one is below when using the tool in high locations.
• Do not over-reach. Keep proper footing and balance at all times. Proper footing and balance
enable better control of the tool in unexpected situations.
• Hold Tool by Insulated Gripping Surfaces when performing an operation.
• Do not leave the tool running. Operate the tool only when hand-held.
• Maintain Labels and Nameplates. These carry important information.
TOOL USE AND CARE:
• Use Clamps or other practical way to secure and support the work piece to a stable platform.
Holding the work by hand or against your body is unstable and may lead to loss of control.
• Do not force Tool. It will do the job better and safer at the rate for which it is designed.
• Do not use Tool if Switch does not turn it "On" or "Off". A Tool that cannot be controlled with
the switch is dangerous and must be repaired. Do not continue to hold down trigger if the
Grease Gun is stalled. This could damage the motor or cause Fire.
8