Modbus ER+ Manual De Instalación página 16

ER+, VR, VS, LT, DV, VRX and VSX models
Standard models (G00) and 3-position models
SNAA720000 & SNAA720100
A-0-B
Ca
Rep. Description
RS485 terminal (serial link) for MODBUS communication
A-0-B
Use the supplied plug-in male connector Phoenix MC 1,5/3-ST-3,5 (3.5 mm, 3 ways, 8 A
with screw tightening for wires from 16 to 28 AWG and 1.5 mm2 section).
JP1
Termination resistor jumper (Rt=120 Ω) for line last actuator
Ca
Electric power supply terminal
For further information, please refer to the actuator manuals
Electric connection
Connect the MODBUS communication wire on RS485 terminal (
Connect the power supply on the connector Ca

1 : neutral (50/60 Hz) or negative (DC)

4 : phase (50/60 Hz) or positive (DC)
Register table for models bought before 12/2021 (v.4.10)
1 0x03 R 2
2 0x03 R 2
3 0x03 R 2
4 0x03 R 2
5 0x03 R 2
6 0x03 R 2
7 0x03 R 2
10 0x03 R 2
11 0x03 R 2
12 0x03 R 2
13 0x03 R 2
14 0x03 R 2
28 0x03/0x10 R/W 2
35 0x03/0x06 R/W 2
36 0x03/0x06 R/W 2
16
JP1
Description
number of cycles
Operating time (hours)
Operating time (seconds)
Software version
EEPROM errors number
Detected defaults number (Intensity limitation + security temperature)
Heating status (1=heating; 2=off; 0=non mesured)
Max recorded temperature
Min recorded temperature
Actuator temperature
Position ("OPEN"= 258 ; "OPENING"= 512 ; "CLOSE"= 260 ;
"CLOSING"= 1024 ; "STOP"= 256 ; "INTER"= 257)
Type of fault (No fault = 0 ; Over-torque = 1 ; Temperature too high = 2)
Actuator adress
The addresses from 248 to 254 are not available. The address 255 is
available but allowes neither action nor response.
Actuator operation : STOP (0) ; OPEN (1) ; CLOSE (2)
INTER position command ("INTER"= 1)
For GF3 models only
SNAA730000 & SNAA730100
JP1
0-A-B ).
EN
A-0-B
N Ph
- +
1 4
0 0 65535
0 0 65535
0 0 3599
0 400 65535
0 0 255
0 0 65535
0 2 2
0 99
-20 99
-20 99
0 0 2
1 247 255
0 0 2
0 0 1
DSBA3305 • Rév. 29/11/2021