Metabo HPT CC 14SF Manual De Instrucciones página 14

English
6. Using a Metallic Block (Fig. 11).
Dimension of
workpiece being cut
Dimension of
Vise (A)
metallic block
(Should be slightly smaller
than the workpiece being cut)
Fig. 11
CUT-OFF WHEEL DISMOUNTING AND MOUNTING
WARNING:
1. Dismounting the Cut-Off Wheel (Fig. 12).
Stopper
Fig. 12
2. Mounting the Cut-Off Wheel.
Thoroughly remove dust from the wheel washers, washer (A) and bolt, then mount the wheel
by following the dismounting procedures in reverse order.
CAUTION:
● Confi rm that the stopper has returned to the retract position after installing or
removing the cut-off wheel.
● Tighten the bolt so that it doesn't come loose during operation of the cut-off
wheel. Confi rm that the bolt has been properly tightened before the power tool
is started.
14
When the cut-off wheel has a reduced outer diameter,
insert between the vise (A) and (B) a metallic block
slightly smaller than the dimension of workpiece being
Vise (B)
cut to use the cut-off wheel economically.
Metallic block
Always turn off the trigger switch and disconnect the power plug
from the receptacle before dismounting or mounting a wheel, to
prevent accidental injury.
(1) Press the stopper and loosen the bolt with a
NOTE: When the mounting shaft for cut-off wheel
Hex. bar
wrench
(2) Remove the bolt, washer (A), and the wheel
spanner.
cannot be fi xed by pressing the stopper, turn
the bolt with a hex. bar wrench while pressing
the stopper.
The mounting shaft for cut-off wheel is fi xed
when the stopper has been lowered.
washer and detach the cut-off wheel.