Uline H-4282 Manual De Instrucciones página 2

Figure 2
Figure 3
Figure 4
Figure 5
PAGE 2 OF 6
ASSEMBLY CONTINUED
Center Divider
1-800-295-5510
2. Connect the crossbar to the center of each side
base using large bolts (attached to crossbar) and
tighten with Allen wrench. (See Figure 2)
3. Slide one gridwall panel into a side base.
(See Figure 3)
NOTE: Gridwall panels have double wires on
long sides. The screws fit between these wires
and attach to a nut on inside of panel.
4. Push one screw through each hole in side base and
the double wires in the gridwall panel, then screw
on washers and nuts. Holding nut with pliers, tighten
screw with screwdriver. (See Figure 3)
5. Repeat on opposite side of the side base.
6. Repeat steps 3-5 with opposite side base.
7. Slide two gridwall panels onto crossbar, one on
either side of the center divider. (See Figure 4)
8. To secure gridwall panels to crossbar, push a screw
through one gridwall panel, the hole in the divider
and through the second gridwall panel, then screw
on washer and nut. Holding nut with pliers, tighten
screw with screwdriver. (See Figure 4)
9. Repeat for second divider hole. (See Figure 4)
10. Attach gridwall panels to one another using optional
connector clips.
uline.com
0421 IH-4282