Wireless Receivers/Speakers Id Settings; Linking Wireless Receivers/Speakers To A Specific Converge Transmitter; Setting A Unique Id - Eos Wireless converge Manual Del Utilizador

Using Your Eos System

Wireless Receivers/Speakers ID Settings

All Eos Converge Transmitters, Wireless Speakers and Receivers have the same ID setting. This
is done so Receivers/Speakers will automatically link with any Converge Transmitter. The Con-
verge Transmitter will link with the first 4 Wireless Receivers/Speakers that it detects.

Linking Wireless Receivers/Speakers to a Specific Converge Transmitter

Due to the incredible range of the Eos system, it is possible for your speakers to receive audio
from a neighbors system. If this happens, or if you wish to run more than one Eos Wireless
System in your house, you can give your Converge Transmitters and the Receivers/Speakers
a unique ID. In giving your system a unique ID your Receivers/Speakers will link only to the
Converge Transmitter that they are paired to.

Setting a Unique ID

To give your Converge Transmitter and Receivers/Speakers a Unique ID, do the following:
1. Turn the power OFF on the Converge Transmitter
2. Turn OFF all power to the Wireless Receivers/Speakers that you wish to link.
3. Turn the power ON on the Converge Transmitter
4. Press and hold the "LINK" button on the bottom of the Converge Transmitter for
seconds until the "Link LEDs" on the Antenna mast starts blinking.
5. Turn on the Wireless Receivers/Speakers that you wish to link to this Converge Trans-
mitter within 60 seconds of pressing the "LINK" button.
Note: to link additional speakers once a unique ID has been set, refer to the "Adding a Speaker to a
System with a Unique ID" section on the following page.
All manuals and user guides at all-guides.com
20
3