Multimetrix EIT 800 Manual De Instrucciones página 9

Metrological checking
Cleaning
Storage
Unpacking
Repacking
Battery replacement
Warning
Fonctional description
Features
Loop tester
Return your instrument to your distributor for any work to be done within or
outside the guarantee.
Periodically wipe the case with a damp cloth and detergent : do not use abrasive
or solvents.
If the meter is not to be used for periods longer than 60 days, remove the
batteries and store them separately.
All equipment has been mechanically and electrically checked before being
dispatched.
However, it is wise to check briefly that equipment was not damaged during
transport. If so, please contact our Marketing Department as soon as possible
and claim carrier legal reserve.
If the equipment is being sent back, please preferably use original packaging and
indicate as clearly as possible the reasons for sending it back on a note enclosed
with the equipment.
The tester continuously monitors the battery voltage and indicates when the
battery need to be replaced.

Disconnect the test leads from the instrument and wait the turn off of the
power.

Unscrew the 2 screws on back cover, then slide the cover.

Take out the batteries and replace with new batteries : 6 batteries 1,5V (AA or
equivalent)

Place back cover and secure by 2 screws.
To avoid electrical shock or damage to the meter, do not get water inside the
case.

Automatic check of wiring : led for good or bad wiring

Voltage measurements : Line-earth AC voltage and Line-neutral AC voltage

Line, neutral and earth wires impedance

Line-neutral impedance calculation

Line-earth loop impedance

Calculation of prospective short circuit current Line-earth and Line-neutral

Low battery indication

Auto-off function

Ultra low power consumption
English
9