Installation And Start-Up - Abus Secvest FUBE50000 Manual De Instalacion Y Uso

Installation and start-up

Installation and start-up
1. Open the wireless control panel housing
by removing the screws on the bottom.
2. Use the base plate as a drilling template
and mark the holes on the wall. Drill the
holes and insert the screw anchor.
When marking out the drill holes,
make sure there are no electrical
wires or cables, pipes or other
important components behind them.
32
3. Insert the three AA alkaline batteries
in the battery compartment.
Make sure the polarity is correct.
Running time in emergency power
mode (in the event of a power
failure) and/or length of battery life
when operating without an
external power supply is roughly
up to 1 - 2 years.
The actual battery life largely
depends on which functionalities
are used (proximity chip reader
etc.) and the frequency of
operations on the control device.