Multi Screen; Sdt10100 Status; Trouble-Shooting - Sveon SDigital TV Serie Manual De Usuario

SDT10100 - User Guide

16. Multi screen

The Multi-Screen option allows you to display up to 9
different channels simultaneously; only the current chan-
nel is shown in live, the rest of channels only display a
thumbnail.
To enable this option press "Play" buttonof the remote
control in a TV channel.
Press arrow buttons left, right, up and down to navigate
through the channels. Press "Ok" to select a channel.
To exit this mode press "Exit" button.

17. SDT10100 status

SDT10100 displays different status messages:
- No signal: The device doesn´t receive DVB-T signal (the antenna cable may be disconnected).
- Without service: The channel has not signal.
- Codified signal: The channel is codified (in pay per view TV channels).
- Locked channel: The channel is locked (for further info please go to 9.3 section in this user guide).

18. Trouble-shooting

Please read carefully the following information about the usage of the device:
- The Standby LED is off:
Cause: The device is disconnected
Solution: Please check if the device is properly connected
- There is no signal:
Cause 1: Antenna is diconnected. Solution: Please check the device connections
Cause 2: Antenna is damaged. Solution: Please check the antenna
Cause 3: There is not DVB-T coverage. Solution: Check with the antenna installator.
- Wighout audio or video signal:
Cause 1: Wrong video output selected. Solution: Press blue button to change output resolution.
Cause 2: A radio station is selected. Solution: Press yellow button to switch between TV and Radio
signal
Cause 3: Movie with AC3 audio format. Solution: Connect a speaker system to your device through
coaxial connection.
- Low quality picture:
Cause: Antena is bad placed or there isn´t enough signal coverage.
Solution: Check the antenna installation
- Codified channel:
Cause: This is a codified channel
Solution: Change the channel
- Forgotten password: Solution: Start again the channel scan.
- The remote control doesn´t work properly:
Cause 1: The receptor is turned off. Solution: Disconect and turn the receptor on.
Cause 2: Frontal panel is covered. Solution: Avoid obstructions the front panel of the device.
Cause 3: The batteries of the remote control are not properly installed. Solution: Check the batteries
installation.
Cause 4: The batteries are ran out. Solution: Change the batteries.
www.sveon.com
English
46