mothercare beech open Guia Del Usuario página 3

fig 11
care of your product
Periodically check all fittings to ensure that none have come loose.
The dresser can be cleaned by wiping with a damp cloth and drying with a soft dry
cloth.
Never clean with abrasive, ammonia based, bleach based, or spirit type cleaners.
Take care when handling or moving the dresser. Careless handling can damage
wooden furniture.
safety notes
This Dresser is not to be used for children over 12 months old or 9Kg, whichever comes
first.
WARNING! Do not leave the child unattended.
All Assembly fittings should be tightened properly. Screws and bolts should not be
loose because a child can squeeze parts of the body, or clothing (e.g. strings,
necklaces, ribbons for babies dummies etc.) could get caught. There would be a
danger of strangulation.
Be aware of the risk of open fire and other sources of strong heat, such as electric bar
fires, gas fires, etc. in the near vicinity of the changing unit.
An older child climbing on the dresser while a child is on the changing surface is
extremely dangerous and must be discouraged.
The Dresser must be used on a level and stable surface.
Once assembled, do not dismantle.
Keep away from trailing cords, drapes or flexes, and away from electric sockets.
Never move the Dresser with the child on it.
5
This work is only to be carried out by a
competent person. Because of the diverse
nature of walls, wall plugs and screws have not
been supplied with this anti-topple device. If
you are at all unsure of the type or suitability of
the wall, or of the appropriate fixings for it,
seek professional advice
Attach the wall strap to the rear of one of the
legs, as near the top as you can, using the
strap screw, inserted through one of the
washers. Place the furniture in its final position,
adjacent to the wall, and fix to the wall, using
fixing and screw appropriate for that wall.
assembly
fig 2
fig 3
fig 4
Place the Towel rail brackets on
the ends of the towel rail, then
attach the brackets to the outer
face of the Left side, passing 2 of
the shorter (40mm) bolts through
the third holes down and into the
holes in the rear of the brackets.
Tighten, using the Allen Key.
Attach the rails to the other side,
as shown, using the 50mm bolts
and the Allen key. Make sure,
with the lower tray rails, that the
grooves are near the top.
Rest the assembly on the side
panel.
Best face upwards, insert the
upper tray (the thicker panel) into
the grooves of the top rails. Slide
it all the way down the grooves.
Insert the lower trays into the
grooves of the lower rails.
2