Starrett W733.1 Manual Del Usuario página 6

GENERAL INFORMATION
Basic Operating Instructions
1. Turn on your tool, check the upper left of the display to see
if the battery symbol is showing. If the battery symbol is
showing (Fig.1A) then go to the "Rechargeable Battery Care and
Maintenance" section, on pg.9. If there is no battery symbol
visible then the battery is charged.
2. Lightly clean the contact point.
3. Fasten the Micrometer into the appropriate holding device if
applicable.
4. You can turn the Micrometer on by either pressing one of the
buttons or moving the spindle.
5. If applicable, pick the unit of measure, inch or millimeter by
pressing the IN/mm button. Note: standard metric micrometers do
not have this function available.
6. Close the Micrometer by moving the spindle and the anvil
measuring faces together and then zero the tool with a quick
press on the Zero / ABS Button.
7. Zero Sequence: When you press the ZERO button the display
will show a dashed line as seen in (Fig.1B). The dashed line will
incrementally disappear from left to right (Fig.1C); Make sure not
to move the spindle during this time. This is a visual reminder to
wait for the tool to zero out. This will happen each time the tool is
zeroed, and takes less than a second to complete.
8. Carefully place the piece to be measured between the spindle
and the anvil measuring faces. Move the spindle to the piece
until contact is made, continue until the friction thimble no
longer moves the spindle. The measurement will be shown on
the display.
9. The Micrometer will automatically enter sleep mode in 30
minutes, if left unattended.
6 PKG08861-UM733.1