Fagor MG9-10 Instrucciones Generales Para La Instalación, Uso Y Mantenimiento página 31

All manuals and user guides at all-guides.com
Burner conversion
Injector replacement.
Dismantle the burner' "I" injectors (Fig. 2) and replace them with suitable ones depending on the gas to be
used (Table 3)
Burner air adjustment.
Set the air regulator "R" (Fig. 2) to the "H" measurement (Table 3) depending on the gas to be used.
To change to city gas, the opening in the wrapping on the rear section of equipment in the 900 range
should be modified, as shown in table 4.
Pilot conversion and adjustment
Injector replacement
To convert to a different type of gas, please proceed as follows (Fig. 3):
- Loosen the "A" lid. Underneath is the injector "B" which must be removed and replaced with the injector
corresponding to the type of gas to be used (tighten it completely).
- Turn the air regulator "C" until the flame stabilises
- Put the lid "A" on again.
To convert to TOWN GAS, the adjustment of the pilot flame will be carried out turning the adjusting screw
"B" until the flame is stable.
After adapting the equipment to another type of gas or to another pressure, other than that for which it had
been previously set, the old instructions should be replaced with the instructions for the new settings, to
enable unambiguous identification of the state of the equipment after modification.
Froth outlet .
In the pressure models it is necessary to connect the 14x12 diameter outlet to the drain pipe
Gas valve outlet pressure adjustment
To adjust the minimum flow of the gas tap, the burner must have been on for at least 15 minutes and then
the F adjusting screw pressed down completely in the case of L.P.G or by adjusting this screw,
anticlockwise until a stable flame is achieved, in the minimum for Natural Gas and Town Gas
IMPORTANT: Never start up the appliance without having previously filled the tub, otherwise overheating
would seriously damage the machine.
Burner ignition
a) Open the gas mains tap.
b) Lightly press the gas mains control to unlock it and turn it anticlockwise to position PILOT (*) (Fig.
5).
c) Keep the control pressed while igniting the pilot and keep it pressed for 20 seconds until the
flame becomes stable, in order for it to stay on when the control is released.
The appliance has a hole on the front panel for manually igniting the pilot.
d)
To ignite the burner, press the control and rotate anticlockwise to the MAXIMUM position. When
the required position is reached, stop pressing the control. The burner will have been ignited by
the pilot.
e) If we position the control clockwise to the OFF position ( ) the burner will turn off.
2.-USE
Turning the appliance on
30