Waeco MAGIC WATCH MWE-1000-4FM Instrucciones De Montaje Y De Uso página 42

_MWE-1000-4FM.book Seite 42 Dienstag, 9. August 2005 11:30 11
Installing MAGIC WATCH
6.4 Fastening the display
The display is mounted near the dashboard (g, page 8). Note the following
points when selecting a place to mount the display:
Note the length of the connection cable to the control electronics.
Mount the display so that there is no danger of injury, if you have to
suddenly brake sharply.
Do not fit the display where an airbag may open. This could cause injury
if the airbag opens.
➤ Fasten the display to a suitable place on the dashboard.
➤ Insert the display plug into a 12 V DC socket such as the cigarette lighter.
Note
You can permanently connect the display.
To do this, remove the plug and connect the cable as follows:
– Black and white cable: +12 V (terminal 30)
– Black cable: earth (bodywork)
6.5 Connecting the control box
Caution
Make sure the polarity is correct.
On some vehicles, the reversing light only works when the ignition
is switched on. In this case, you must switch on the ignition in
order to identify the positive and earth wires.
The complete circuit diagram can be found in h, page 8.
No. in
h, page 8
1
2
3
4
5
6
42
Description
Control electronics
Reversing light
Red cable of the connection cable of the control
electronics
Black cable of the connection cable of the control
electronics
Sensors
Display connection
magic watch